Description:
Use this solution for removing and reinstalling a new heat bed assembly.
Process:
1) Remove top acrylic panel
--
2) Loosen upper screw from Z-Rod (For reinstalling, lift Z-rod up out of coupling until visible light can be seen through the middle of the coupling)
3) Move hot end to the front of the machine to keep out of the way
--
4) Securely hold smooth Z-Rods while removing screws
--
5) While holding the bed steady, slide smooth rods out of the printer and set aside
--
6) Place bed inside printer
--
7) Remove the back panel. On the right side you will find the RAMBo Board. Remove the Heat Bed wiring.
--
Threaded rod with bed can now bed removed from the printer. Remove threaded rod from old bed and install into new. (Rods should remain well lubricated! See AXIOM - Rod Lubrication). Repeat steps backwards for install.
Please open a Tech Ticket if you have any questions or need assistance with this process.