How-to Guides
Description: You will learn how to open the hot end and clear jammed filament. 1. Heat hot end to 240 degrees for ABS, 220 for PLA, 290 for Polyca...
Fri, 4 May, 2018 at 10:37 AM
This document will help you remove and replace your ERC unit for a Axiom Direct Drive. First, confirm a couple things: 1. AXIOM series printer (Says AXI...
Thu, 24 Jan, 2019 at 1:37 PM
1) Download the AstroBox image for your Raspberry Pi. It can be found here: DropBox. Unzip the .zip file, you should see the AstroBox image file, it...
Wed, 18 Apr, 2018 at 3:25 PM
Prior to installing the glass plate, you will need to prepare your surface with the appropriate bed adhesion. Supplied with the printer is the product Wolfb...
Wed, 18 Apr, 2018 at 3:11 PM
The Wolfbox is the Wi-Fi board that will give you control of the printer, and how you will start print files over Wi-Fi. It will be attached to the astropri...
Fri, 18 May, 2018 at 1:49 PM
AXIOM - Installing Glass Plate Prior to installing the glass plate, you will need to prepare your surface with the appropriate bed adhesion. Suppl...
Wed, 18 Apr, 2018 at 3:12 PM
Sometimes, a bed heating failure will occur if the connector becomes stressed and continuity is broken. A momentary continuity break results in arching and...
Fri, 22 Jun, 2018 at 11:13 AM
Turn the printer off and unplug it from the wall Remove the three screws and spacers above the heat block. Pull the assembly down and remove the circu...
Tue, 19 Jun, 2018 at 2:49 PM
Purpose of this tutorial: The attached PDF will guide you through the process of installing the Axiom HEPA filter on your machine. How does it work: ...
Tue, 26 Feb, 2019 at 4:30 PM