Maintanence

HD - Cleaning the Hot End and Nozzle
Description:   This solution will show you how to change a nozzle on any JR type hot end. This is done to switch between nozzle sizes or to remove the n...
Mon, 17 Aug, 2015 at 11:16 AM
HD - Rod Lubrication
For any of the HD models, it is very important to properly and regularly lubricate your printer. This will help your printer last longer and generate better...
Mon, 17 Aug, 2015 at 11:16 AM
HD - Belt Tensioning
Description: This solution will cover how to tighten the belts on your HD series Airwolf 3D printer.  Process: 1) Check the Belt Ten...
Mon, 17 Aug, 2015 at 11:16 AM
HD - Check X coupling
In the upper rear right corner bracket is a stepper motor.  The motor shaft of that stepper motor is coupled to a rod and belt pulley that moves the printer...
Wed, 3 May, 2017 at 10:04 AM