Troubleshooting

HDx - What is a "mouse bite" and how do I fix it?
Description: This solution goes over what a mouse bite is, potential causes of mouse bites, and how to fix them. You will need a set of wire or plas...
Mon, 17 Aug, 2015 at 11:01 AM
HDx - Cleaning the Hot End and Nozzle
Description:   This solution will show you how to change a nozzle on any JR type hot end. This is done to switch between nozzle sizes or to remove the...
Mon, 17 Aug, 2015 at 11:01 AM
HDx - Nozzle isn't Heating
Description: Is your nozzle(s)/hot end not heating up? Below are a couple steps for diagnosing the issue. Process: Hot End: As...
Mon, 17 Aug, 2015 at 11:02 AM
HDx - Heat Bed Movement (Type 1)
Description: When the heat bed has difficulties moving up or down, this is caused by the Z-rod being out of alignment with the Z-motor. The followin...
Mon, 17 Aug, 2015 at 11:02 AM
HDx - Heat Bed Movement (Type 2 & 4)
Description: The following instructions guide you troubleshooting issues regarding the bed not lowering or rising, particularly if the...
Mon, 17 Aug, 2015 at 11:02 AM
HDx - Repetier-Host - Connectivity Troubleshooting
Description: Troubleshoot the cause of your connection issues by following the below options.   COM Port 1) In order for Repe...
Mon, 17 Aug, 2015 at 11:02 AM