Troubleshooting
Description:
This solution goes over what a mouse bite is, potential causes of mouse bites, and how to fix them. You will need a set of wire or plasti...
Mon, 17 Aug, 2015 at 5:17 PM
Description:
This solution will show you how to change a nozzle on any JR type hot end. This is done to switch between nozzle sizes or to remove the n...
Mon, 17 Aug, 2015 at 5:17 PM
Description:
Is your nozzle(s)/hot end not heating up? Below are a couple steps for diagnosing the issue.
Process:
Hot End: Assembly t...
Mon, 17 Aug, 2015 at 5:18 PM
Description:
When the heat bed has difficulties moving up or down, this is caused by the Z-rod being out of alignment with the Z-motor. The following ...
Mon, 17 Aug, 2015 at 5:18 PM
Description:
The following instructions guide you troubleshooting issues regarding the bed not lowering or rising, particularly if there is ...
Mon, 17 Aug, 2015 at 5:19 PM
Description:
Troubleshoot the cause of your connection issues by following the below options.
COM Port
1) In order for Repetier-Host...
Mon, 17 Aug, 2015 at 5:19 PM