The Wolfbox is the Wi-Fi board that will give you control of the printer, and how you will start print files over Wi-Fi. It will be attached to the astroprint.com account you created to allow access and use of your stored .STL files and G-code. This board is included on the AXIOM Series printers. This process is for your first use of the Wolfbox.


Process:

 

 If you are setting up via Ethernet, connect the Ethernet Port to the back of your printer before starting these instructions


Printer on. A surge protector is highly recommended! 


1) Connect to the printer’s hot spot for initial setup (Wi-Fi). 

  • The hot spot will be labelled "AXIOM..." followed by your printer’s serial number. 
  • This hot spot is temporary and will be shut off at the end of setup.

--


2) Open a Google Chrome Browser window and type “10.10.0.1”. This will take you to the Airwolf 3D Printer setup page. 


   

--


3) Click “Begin Setup”.

--


4) Confirm Printer Name matches your serial number, then click “Internet Setup”. 

  • You can find this number located inside the print in the bottom left corner (barcode).

--


5) Select the Wi-Fi network you wish to connect your printer to and click “Connect”. If your network has a password, you will need to type this in and click “Connect” again. 

  • If you are setting up via Ethernet, this step will be automatic.

--


6) Success! Click on “Astroprint Account” to connect the printer to the Astroprint.com account you previously created. 

--


7) Type in your email address and password for your Astroprint account, then click “Printer Connection”. 

--


8) Connect one end of the small USB jumper cable to the RAMBo board (USB) and the other end to the Wolfbox (Wi-Fi).  Click “Continue”. 

--


9) Verify the Baud Rate is set to 250000 and click “Connect”.

--


9) You’re Done! Feel free to Share or Tweet or click “Start Printing!”

--


Please open a Tech Ticket if you have any questions or need assistance.