How-to Guides
With the AXIOM, Loading and Removing filament is a breeze. This printer has an auto feed system which will pull the filament to the hot end for you! Loadi...
Wed, 18 Apr, 2018 at 3:14 PM
Description:
!!!!!!!! Do Not Clean the Nozzle While the Printer Is On !!!!!!!!
HEAT UP THE HOT END TO THE APPROPRIATE TEMPERATURE FOR THE MATERI...
Fri, 16 Nov, 2018 at 12:58 PM
This guide will show you how to replace a standard bowden ERC unit with a Direct Drive ERC unit. You can also use it as a guide to swap out a Direct Drive ...
Wed, 30 Mar, 2022 at 2:53 PM
This guide will instruct you on how to replace the nozzle on the AXIOM series of 3D printers. Preheat the hot end to the temperature of the last used mate...
Wed, 30 Mar, 2022 at 4:35 PM
The Wolfbox is the Wi-Fi board that will give you control of the printer, and how you will start print files over Wi-Fi. It will be attached to the astropri...
Fri, 18 May, 2018 at 1:50 PM
Description:
This solution will cover how to install a webcam to your AXIOM printer and using the astroprint.com interface for the webcam.
R...
Wed, 18 Apr, 2018 at 2:28 PM
Description:
**This solution is only for those who cannot see a broadcasting hot spot or see the printer listed under "Monitor" in their ast...
Wed, 18 Apr, 2018 at 2:28 PM
Description
This guide provides instruction on replacing the hobbed bolt. The hobbed bolt is a grooved bolt inside the extruder assembly. It...
Fri, 16 Nov, 2018 at 12:09 PM
Description If your AXIOM has the new version hot end with four screws on the top, you do not need to adjust the tension of the belts. Over...
Fri, 16 Nov, 2018 at 12:54 PM
Prior to installing the glass plate, you will need to prepare your surface with the appropriate bed adhesion. Supplied with the printer is the product Wolfb...
Wed, 18 Apr, 2018 at 3:20 PM