Description:


1) Prior to installing your glass into the building area, we will need to add Bed Adhesion. Depending of what filament you are using, this will vary. Please see our solution Bed Adhesion for the right bed adhesion for you. If you have PET Tape installed onto your glass and would like to use a brush on adhesion, you can flip the PET Tape down towards the heat bed and apply the solution straight onto the glass side. 

--


2) Place the glass with the adhesion face up onto your heat bed.

--


3) The 4 binder clips will be used to hold the glass to the heat bed. The front left clip needs to be offset from the corner by 3 to 4 inches. This is to prevent the hot end from colliding with the clip when it goes to its home position. Place the other 3 binder clips on each corner of the bed.

--


Please open a Tech Ticket if you have any questions or need assistance with this process.