How-to Guides
Description: How to create and setup a dual color print for your AXIOM dual nozzle printer, this guide shows TinkerCad but the process is the same for w...
Mon, 12 Nov, 2018 at 4:44 PM
This guide will show you how to replace a standard bowden ERC unit with a Direct Drive ERC unit. You can also use it as a guide to swap out a Direct Drive E...
Tue, 11 Apr, 2023 at 1:53 PM
This guide will instruct you on how to replace the nozzle on the AXIOM series of 3D printers. Preheat the hot end to the temperature of the last used m...
Wed, 30 Mar, 2022 at 4:40 PM
This guide will show you how to unbox and set up the AXIOM series of 3D printers. Shown here is the AXIOM 20, as the other models will be very similar. ...
Thu, 7 Apr, 2022 at 10:24 AM
This guide will show you how to open up the dual direct drive hotend and purge the barrel. You will need to heat the printer up to the temperature for the ...
Thu, 29 Mar, 2018 at 12:26 PM
You can not bring in a single model file and split different sections off to print with different nozzles. The dual printing process begins with the modeli...
Fri, 18 May, 2018 at 9:22 AM
You will learn how to remove open up the hot end and remove the filament if it becomes stuck in the PTFE tubing. You will need to heat the printer up ...
Wed, 18 Apr, 2018 at 2:32 PM
Description: Wiring should only be handled when instructed to do so by an Airwolf 3D technician. Wire coloring may vary. This is a detailed wiring ...
Wed, 18 Apr, 2018 at 1:12 PM
The Wolfbox is the Wi-Fi board that will give you control of the printer, and how you will start print files over Wi-Fi. It will be attached to the astropri...
Fri, 18 May, 2018 at 1:51 PM
Prior to installing the glass plate, you will need to prepare your surface with the appropriate bed adhesion. Supplied with the printer is the product Wolfb...
Wed, 18 Apr, 2018 at 3:13 PM