Troubleshooting
How Does It Look: What Causes This: Only one type of malfunction can produce XY-axis layer shifting in the EVO Additive Manufacturing Center: the s...
Fri, 16 Nov, 2018 at 1:39 PM
After running out of filament, it is not possible to remove remaining filament in feeders. Insert new filament into feeder opening, press FILAMENT CONTR...
Fri, 9 Nov, 2018 at 1:10 PM
Auto-leveling errors are most likely the result of a poor connection between the nozzle and the bed. Make sure that the M3 screw holding the orange sens...
Fri, 9 Nov, 2018 at 1:17 PM
1. Use correct Wolfbite (apply while glass is cold). ABS/PETG – Wolfbite Original PLA – Wolfbite Nano (works best at 60-80°C) PC – Wolfb...
Fri, 16 Nov, 2018 at 2:59 PM
Too close (filament jamming into glass) 1. Make sure nozzle and bed rails are auto-leveling correctly (nozzle will quickly retract once rail is cont...
Fri, 9 Nov, 2018 at 2:03 PM
A jammed hot end is a common problem with 3D printing, and can even occur during a print. This is usually catastrophic, but can easily be remedied, and with...
Tue, 19 Oct, 2021 at 3:12 PM
If HydroFill or nylon is exposed to humidity, printing performance can degrade quickly. However, EVO’s heated chamber will eventually dry the filament. ...
Fri, 9 Nov, 2018 at 2:06 PM