How-to Guides

EVO - Unboxing and getting started
EVO - Unboxing and getting started
Mon, 15 Oct, 2018 at 9:36 AM
EVO - Switching Extruder Modules
CAUTION: Do not plug or unplug wires while machine is powered on. 1. Remove filament from both nozzles (if necessary, cut filament as shown) 2....
Wed, 7 Nov, 2018 at 3:48 PM
EVO - Changing Nozzles
IMPORTANT: Only change one nozzle at a time. If both nozzles are loosened, entire hot end assembly will become loose. 1. Heat nozzle to temperature of i...
Fri, 9 Nov, 2018 at 10:20 AM
EVO - Clean Nozzle
Every 100 hour print hours, clean nozzles for accurate auto-leveling 1. Press SERVICE MODE. 2. Power down machine. 3. Carefully take wire brush ...
Fri, 9 Nov, 2018 at 2:13 PM
EVO - Cleaning Bed Rails
Every 100 print-hours, clean bed rails for accurate auto-leveling. 1. Auto home and power down machine 2. Use razor blade to scrape film off steel b...
Wed, 7 Nov, 2018 at 3:52 PM
EVO - Leveling Nozzles
To level nozzles, perform the following steps: 1. Loosen right bolt and tilt until hot ends are approximately level. 2. Tighten both bolts...
Wed, 7 Nov, 2018 at 3:47 PM
EVO - Connecting To The Internet
Connect via WiFi: 1. Select SETTINGS 2. Select WI-FI SETTINGS 3. Choose your network and enter your password 4. Select CONNECT Connect v...
Fri, 9 Nov, 2018 at 2:13 PM
EVO - Update Touchscreen Firmware
Update the Touchscreen on your EVO by performing the following steps:     1. Make sure EVO is connected to the internet     2. Select SETTINGS  ...
Fri, 9 Nov, 2018 at 2:28 PM
EVO - Update Genesis Board Firmware
NOTE: Once Touchscreen is up to date, latest firmware for GENESIS microcontroller will become available in Touchscreen’s internal drive. 1. Select SETTI...
Fri, 9 Nov, 2018 at 2:28 PM
EVO - Change/Reset ScreenLock Passcode
By default, your Touchscreen passcode is 0000. To change your password, navigate to SETTINGS > DIAGNOSTICS > CHANGE PASSWORD. Passcodes must be 4-...
Fri, 9 Nov, 2018 at 2:59 PM